购物车

{{ successMessage }}
{{item.orderingCode}}
数量: {{ item.quantity }}
{{currencySymbol}}{{item.pricing.totalPrice | intlNumber('zh-CN','USD')}}
小计 ({{totalQty}} {{totalQty === 1 ? "件" : "件"}}):
{{currencySymbol}}{{cartSummary.total | intlNumber('zh-CN','USD')}}
测试站点
您还未被收费。

EPX Plus Mobile Heater Configuration

The EPX Plus mobile heater comes with an in-built CCD 401 and ready to communicate with Avensor. Check the following connections during the initial setup.

CCD 401 EXP Controller RS-485-1
A +
B -
GND GS

 

No configurations are needed for the EPX Plus mobile heater. The user must enter the following values while adding the device in the Avensor application.

Parameter Value
Address 1
Data bits 8
Stop bits 1
Parity None
Baud rate 38400